Short story – navigate to the Node Details screen and: in iOS, swipe left on the connection and tap “Disconnect”, in Android, long-press the connection and select “Disconnect” from the popup. Reboot your node once a week to clear out temporary and log files and give the operating system a fresh start. During that latency you may not be able to connect to some nodes.
#Android echolink app faq registration#
Once powered and connected, it can take as much as 10 minutes before your registration has propagated through all the registration servers. If you power it down the registration will expire and will not be active again until you power it up again. Your ClearNode uses very little power, if you keep it powered and connected to the Internet all the time it’s registration with the AllStar servers will always be fresh so you can instantly connect to remote nodes. In the Node Setup screen of the ClearNode mobile apps, long press the title of any setup item and you will presented and explanation of the purpose of the item and its options.
#Android echolink app faq software#
If there are red indications in the bar graphs, either high or low, you either need to adjust the deviation in your HT or compensate for your HT in the “Adjust USB Audio Gain for VOIP” section – lower or raise “To VOIP (rxmixerset)”. You’ll need at least 5 seconds of continuous PTT with DTMF tones for ClearNode to analyze the audio. Turn on “Audio Analysis” in the node setup pages and observe the audio levels in the “Adjust USB Audio Gain for VOIP” section (see “AUDIO TUNING” above). We’ve put together an overview page on managing WiFi on your ClearNode, it’s well worth a read – especially for you road warriors that often have to switch between your home/office WiFi and your mobile hotspot – MANAGING WIFI.ĭTMF commands are un-reliable or don’t work at all, are they supported ?ĭTMF commands are supported and a default set has been deployed in rpt.conf – contact us directly for the list – we don’t publish them or make them public.ĭifficulty with DTMF is nearly always a function of mismatched deviation levels between your HT and the decoder in Asterisk. I’m struggling with connecting my ClearNode to WiFi, or switching it between WiFi Networks
Beware the PowerBank manufacturer that claims 4 amps capacity but doesn’t mention that it is shared between 2 ports and the max on each port is 2 amps.
ClearNode needs at least 2.5 amps at 5.2V to function properly. But take care when you purchase – read the fine print. Such batteries are quite inexpensive these days. ClearNode will run for 4 or 5 hours on a 10,000 mAhr battery. My personal preference is to power my ClearNode from a 5V USB PowerBank battery. There is so much variance in the quality of vehicle USB power that it’s our assessment is that it ends up being a threat to the proper functioning of your ClearNode. Keep your eye on that red LED under the antenna on the edge of the Raspberry Pi PCB – if that’s blinking, ClearNode is experiencing an under-volt condition – that’s not a good thing – in particular you may corrupt the SD Card.Ĭan I power ClearNode of my vehicle USB outlet ? ClearNode needs a stable 5.2 V and at least 2.5 amps. Aside from noise, a lot of the cheaper PSUs have unstable voltage and/or can’t supply the current ClearNode needs. The compact form factor of ClearNode can be susceptible to noisy switching power supplies. We’d rather you didn’t – we go to some length to source a quality PSU for ClearNode.
0 kommentar(er)
